The dry-type transformer is constantly improving its operating effect during the operation process. The dry-type transformer is also constantly heating up during operation and operation. The calorie of the dry-type transformer body is also constantly increasing. At this time, when the heat reaches a certain level, it needs to be cooled. However, the cooling method of the dry-type transformer is different from the key method, which should be determined in detail according to the structural characteristics and model specifications of the dry-type transformer. What are the cooling methods and characteristics of common dry-type transformers? We will introduce the following aspects in detail:
Key methods:
1. Open type: It is a common method. Its body is in direct contact with the air and is integrated into a relatively dry and clean room (when the operating temperature is 20 degrees, the air humidity cannot exceed 85%). There are generally two cooling methods: air overtemperature protection and air cooling.
2. Closed type: The device is placed in a closed casing and is not in direct contact with the air (due to poor sealing and heat dissipation, it is suitable for mines and belongs to the flameproof type).
3. Casting type: Use epoxy resin glue or other epoxy resin casting as the main insulation layer. It has a simple structure and small size, and is suitable for dry-type transformers with smaller volumes.
Features:
1. Safe, fireproof, zero pollution, and can be directly operated in the load center;
2. Adopting China's advanced technology, high impact toughness, strong short-circuit resistance, small partial discharge, good heat resistance, high stability, and long service life;
3. No consumption, low noise, significant energy-saving effect, and maintenance-free;
4. Good heat dissipation performance, strong overload capacity, and can increase volume operation when forced water cooling;
5. Good waterproof performance, suitable for operation in high humidity and other extreme environments;
6. Dry-type transformers can be equipped with a complete temperature measurement and protection system. The intelligent signal temperature control system software can automatically identify and display the operating temperature of the three-phase windings, automatically start and stop the centrifugal fan, and has alarm, power-off and other function settings;
7. Small size, light weight, small footprint, low installation cost.
The above are the main methods and main characteristics of common dry-type transformer cooling. The cooling of dry-type transformers should choose the appropriate cooling method according to the actual situation. For detailed introduction of dry-type transformer cooling, please contact our manufacturers or professional technicians for communication and understanding.
